Traduzione in corso passo 2
Passo 2
-
Discharge the capacitor to avoid getting shocked.
-
Dislodge clamps on all 4 sides and remove rear metal plate.
-
Release lens & CCD flex from ZIF sockets by gently lifting the black locking bar at the rear of the sockets. These may be a little stiff so care is needed.
-
Remove lens from housing and replace. Reverse steps for re-assembly
-
Area highlighted in orange can be lost easily. Please keep your eyes on this part. If unit is tilted part will fall out.
[* green] Discharge the capacitor to avoid getting shocked. | |
[* black] Dislodge clamps on all 4 sides and remove rear metal plate. | |
- | [* yellow] Release lens & CCD flex from ZIF sockets |
+ | [* yellow] Release lens & CCD flex from ZIF sockets by gently lifting the black locking bar at the rear of the sockets. These may be a little stiff so care is needed. |
[* black] Remove lens from housing and replace. Reverse steps for re-assembly | |
[* orange] Area highlighted in orange can be lost easily. Please keep your eyes on this part. If unit is tilted part will fall out. |
I tuoi contributi sono usati su licenza in base alla licenza open source Creative Commons.