iPhone 7 Plus Display Assembly Replacement

Passo 1 Display Assembly




• Make sure the battery is disconnected before you disconnect or reconnect the cables in this step.
• Use the flat end of a spudger or a fingernail to disconnect the two lower display connectors by prying them straight up from their sockets on the logic board.
• To re-attach press connectors, press down on one end until it clicks into place, then repeat on the other end. Do not press down on the middle. If the connector is even slightly misaligned, the connector can bend, causing permanent damage.
• If you have a blank screen, white lines on the display, or partial or complete lack of touch response after reassembling your phone, try disconnecting and carefully reconnecting both of these cables and make sure they are fully seated.
Traduci
8 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 2




• Remove the three tri-point Y000 screws securing the bracket over the front panel sensor assembly connector:
• One 1.3 mm screw
• Two 1.0 mm screws
• Remove the bracket.
Traduci
11 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 3
• Disconnect the front panel sensor assembly connector from its socket on the logic board.
• This press connector should also be reconnected one end at a time to minimize the risk of bending.
Traduci
4 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento
Passo 4
• Remove the display assembly.
• During reassembly, pause here if you wish to replace the adhesive around the edges of the display.
Traduci
7 commenti
Aggiungi un commento
Aggiungi Commento
1024
Annulla Pubblica commento

Autore

con 2 altri collaboratori

Paige Reisman

Membro da: 04/07/14

23.612 Reputazione

15 Guide realizzate

Distintivi: 38

• 
• 
• 

+35 altri distintivi

Incorpora questa guida

Scegli una dimensione e copia il codice qui sotto per incorporare questa guida come un piccolo widget sul tuo sito/forum.

Anteprima