Aggiusta la tua roba ComunitĂ  Store

Questa guida ha delle modifiche più recenti. Passa all'ultima versione non verificata.

iHome iH5 Charging Dock Replacement

Introduzione

This is a replacement guide for the charging dock on the iHome iH5.

Cosa ti serve

  1. iHome iH5 Charging Dock Replacement, Charging Dock: passo 1, immagine 1 di 1

    • Remove the eight 5/16 inch screws with a #2 Phillips screwdriver.

    Traduci

  2. iHome iH5 Charging Dock Replacement: passo 2, immagine 1 di 1

    • Use tweezers to unplug the three wires connected to the circuit board. If the wires are tight pliers might work better.

    Traduci

  3. iHome iH5 Charging Dock Replacement: passo 3, immagine 1 di 1

    • Remove the five 5/16 inch screws from the circuit board.

    Traduci

  5. iHome iH5 Charging Dock Replacement: passo 4, immagine 1 di 2 iHome iH5 Charging Dock Replacement: passo 4, immagine 2 di 2

    • Flip the circuit board over.

    • There are capacitors all over the back side of the board. Be careful not to touch these capacitors (blue cylinders) as they can discharge—giving you a shock.

    • Unplug the eight wires attached to the circuit board with tweezers. If the wires are tight pliers might work better.

    • There is on wire in the orange box.

    • There are two wires in the yellow box.

    • There are five wires in the green box.

    Traduci

  6. iHome iH5 Charging Dock Replacement: passo 5, immagine 1 di 1

    • Remove the following four screws securing the iHome iH5 charging dock.

    • Use a #2 Phillips screwdriver to remove the four screws.

    Traduci

  7. iHome iH5 Charging Dock Replacement: passo 6, immagine 1 di 1

    • Gently remove the charging dock from the iHome iH5 by pulling it up.

    Traduci

  8. iHome iH5 Charging Dock Replacement: passo 7, immagine 1 di 1

    • Remove the final screws connecting the iH5 charging dock to the plastic holding platform

    • Use a #2 Phillips screwdriver to remove the 3/8 inch screws.

    Traduci

  9. iHome iH5 Charging Dock Replacement: passo 8, immagine 1 di 1

    • Replace the old iH5 charging dock with new iH5 charging dock.

    Traduci
Conclusione

To reassemble your device, follow these instructions in reverse order.

Autore

con 4 altri collaboratori

Dustin Lamb

Membro da: 03/13/14

103 Reputazione

1 Guida realizzata

Distintivi: 2

Team

New Mexico State, Team 1-6, Easley Spring 2014 Membro di New Mexico State, Team 1-6, Easley Spring 2014

NMSU-EASLEY-S14S1G6

5 Membri

4 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 7

Ultimi 30 Giorni: 15

Tutti i Tempi: 965