Salta al contenuto principale

Introduzione

This guide will show how to install a new mother board in the iHome. For help troubleshooting click the link to our troubleshooting page iHome IH11 Troubleshooting.

Parti

Nessuna parte specificata.

  1. Unscrew the two 9.0 mm screws with a Phillips #1 screwdriver.
    • Unscrew the two 9.0 mm screws with a Phillips #1 screwdriver.

    • Remove the translucent bottom case.

  2. Remove the two Phillips #1 9.0mm screws on the back of the iHome. Repeat the previous step for the two 9.0mm screws on the bottom.
    • Remove the two Phillips #1 9.0mm screws on the back of the iHome.

    • Repeat the previous step for the two 9.0mm screws on the bottom.

    • Carefully slide the back cover off. There are wires connected to the back cover.

  3. Remove the aluminum bracket by loosening the two nuts and removing the 8.0 mm bolts.
    • Remove the aluminum bracket by loosening the two nuts and removing the 8.0 mm bolts.

    • Pull the bracket out.

  4. Remove the two 12.0mm screws that hold the motherboard with a Phillips #1 screwdriver. Slide the motherboard gently out.
    • Remove the two 12.0mm screws that hold the motherboard with a Phillips #1 screwdriver.

    • Slide the motherboard gently out.

  5. Solder each wire to corresponding input on the motherboard.
    • Solder each wire to corresponding input on the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Cal Poly, Team 14-9, Maness Spring 2013 Membro di Cal Poly, Team 14-9, Maness Spring 2013

CPSU-MANESS-S13S14G9

5 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 248