Introduzione

The button on the device's back may sometimes become damaged or dirty and therefore need replacement. This guide will go over how to access the back button's contact in order to clean or replace.

Using the Triangle driver remove the four 7.5 mm screws.
  • Using the Triangle driver remove the four 7.5 mm screws.

  • The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

Aggiungi Commento

Turn the device so that the the device is on its side.
  • Turn the device so that the the device is on its side.

  • Hold the back and belly on the device and gently pull apart.

  • Pulling with too much force might damage a few cables inside, so caution is needed.

Aggiungi Commento

  • With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

Aggiungi Commento

  • Locate the gray rubber contact in the middle of the bottom half of the device. Using the spudger, lift one corner of the contact until it pops loose.

  • Grab the contact and gently pull until the other side detaches.

  • When replacing the contact pad, use the narrow leads on the pad to pull it into place by twisting around the tips of the tweezers.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Mitchell Gentry

Membro da: 14/02/2018

651 Reputazione

6 Guide realizzate

Team

USF Tampa, Team S6-G2, Eyestone Spring 2018 Membro di USF Tampa, Team S6-G2, Eyestone Spring 2018

USFT-EYESTONE-S18S6G2

3 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 2

Tutti i Tempi: 30