1. Turn the device over with its display down.
    • Turn the device over with its display down.

    Aggiungi Commento

  2. Remove the battery cover, pressing down on the tabs and sliding.
    • Remove the battery cover, pressing down on the tabs and sliding.

    Aggiungi Commento

    • Unscrew the two (2) #00, 10 mm screws located below the mic on the back cover.

    Aggiungi Commento

  3. GIVE TOOLS. FIX FOREVER.

    GIVE TOOLS.

    FIX FOREVER.

    Spread the Fixmas cheer.

    GIVE TOOLS. FIX FOREVER.

    Spread the Fixmas cheer.

    • Carefully pry up the top end of the back cover using one finger.

    Aggiungi Commento

    • Remove the back plate by using a plastic removal tool to pry the back cover up around the edges.

    Aggiungi Commento

    • De-solder the white and black speaker wires from their soldering points.

    • Speaker soldering points are located on the thin section of the blue circuit board, and are marked with “SP+” and “SP-”.

    • Keep in mind which color wire was connected at which terminal.

    Aggiungi Commento

    • Remove the damaged speaker from its place at the very bottom of the case, just below the battery input.

    • You will have to break the glue holding the speaker in place before removing it.

    Aggiungi Commento

    • Replace the damaged speaker and re-solder to the original solder points.

    • Ensure that the negative wire is soldered to the “SP-” while the positive wire is soldered to the “SP+” point.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Alex

Membro da: 28/10/2013

758 Reputazione

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 14

Tutti i Tempi: 999