Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Essential Electronics Toolkit$29.95-
Remove the batteries from your controller (if installed). If you do not have a TR8 screwdriver, the bit is in the Essential Electronics Toolkit.
-
Remove the screw under the battery cover label. To do this, puncture the label where it is marked. It is located roughly in the center of the battery bay on the controller.
-
Remove the side trim from the controller, along with the 4 TR8 screws. Set the trim and screws aside somewhere safe.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:iFixit Opening Tool$1.99-
With the screws removed from the back, flip the controller to the front. Remove the front plastic cover.
-
With the front plastic cover removed, remove the back shell. A plastic pry tool can be used if it is easier.
-
Remove the shell once the battery tabs are released.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:iFixit Opening Tool$1.99-
Remove the power button cover from the controller. If the LB/RB assembly is separate, remove this next. A plastic pry tool can also be used.
-
Remove the wireless sync button. Place this on a bright surface to avoid misplacement.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Precision Utility Knife$4.99-
Before cutting the heatshrink, make TWO alignment marks (non-crossing).
-
After making alignment marks, cut the heatshrink off using a utility knife.
-
Using the old heatshrink as a reference, cut two new pieces.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After cutting the heatshrink tubing, do a test alignment before applying glue.
-
These controllers use double sided tape from the factory. Note the dimple side and clean the magnet and frame. Goo Gone can be used on difficult residue.
-
Once the parts are reasonably clean, do a test alignment and apply tape for final installation.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After verifying the alignment is correct, apply glue to the controller. It is best to let it cure for 24 hours if possible.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Heat Shrink Tubing Assortment$7.99-
Once the glue cures, add new heatshrink tubing.
-
Annulla: non ho completato questa guida.
Altre 9 persone hanno completato questa guida.
4 Commenti
Do you know any specs on the magnet itself? I have a controller that is missing a magnet, and can’t find any information on the strength of the magnet. Without that there’s no way to get a replacement.
same here cant find it any were
found some on eBay
Ma gachette RT reste enfoncé c quoi le problème.
Merci d'avance