Womier K66 Mechanical Keyboard Switch Replacement

Introduzione

If your Womier K66 mechanical keyboard has any faulty or problematic key switches, use this guide to replace the key switches. The faulty key switch may not register your presses or may register multiple inputs from a single key press instead.

In steps 3 and 6 of the guide, it requires you to desolder and solder in key switches to the board.

Cosa ti serve

Passo 1 Switch

Womier K66 Mechanical Keyboard Switch Replacement, Switch: passo 1, immagine 1 di 3

Womier K66 Mechanical Keyboard Switch Replacement, Switch: passo 1, immagine 2 di 3

Womier K66 Mechanical Keyboard Switch Replacement, Switch: passo 1, immagine 3 di 3

Remove the keycaps from the keyboard using the keycap remover.

Modifica

Passo 2

Womier K66 Mechanical Keyboard Switch Replacement: passo 2, immagine 3 di 3

Flip the keyboard over so the backside is facing up.
Use the Phillips #0 screwdriver to remove the fourteen 1.52 mm screws.
Remove the back plate of the keyboard.

Modifica

Passo 3

Womier K66 Mechanical Keyboard Switch Replacement: passo 3, immagine 3 di 3

Attrezzo utilizzato in questo passaggio:

Desoldering Pump

$3.99

Compra

If you're unfamiliar with solder or need a refresher, review the How to Solder and Desolder guide.
Set your soldering iron to 400 °C.
Apply the soldering iron to the solder joints and remove the solder with the desoldering pump.
Be careful when soldering as the iron is very hot.