Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

This repair might be needed if your 3D glasses will not connect to your Sony PlayStation 3D Display.

  1. Remove the base by pushing in the button and sliding out the unit. Remove the base by pushing in the button and sliding out the unit.
    • Remove the base by pushing in the button and sliding out the unit.

  2. Remove USB port cover from back plate with a metal spudger. This will prevent the cover from falling under the back plate once it is removed. This will prevent the cover from falling under the back plate once it is removed.
    • Remove USB port cover from back plate with a metal spudger.

    • This will prevent the cover from falling under the back plate once it is removed.

  3. With the  Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate. With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.
    • With the Phillips #02 screwdriver, remove the six 6 mm length x 6 mm head screws from the back plate.

    • With the Phillips #02 screwdriver, remove the ten 6 mm length x 8 mm head screws from the back plate.

    • These screws have different threads and need to be kept separate.

  4. Remove back plate with a plastic opening tool by slowing prying around the entire plate. Be gentle to avoid breaking the plastic clips which hold the plate. Once separated the plate easily lifts off.
    • Remove back plate with a plastic opening tool by slowing prying around the entire plate.

    • Be gentle to avoid breaking the plastic clips which hold the plate.

    • Once separated the plate easily lifts off.

  5. With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws that hold the 3D Sync Transmitter in place. With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws that hold the 3D Sync Transmitter in place.
    • With the Phillips #01 screwdriver, remove the two 5 mm length x 7 mm head screws that hold the 3D Sync Transmitter in place.

  6. Carefully pry off the 3D Sync Transmitter with the plastic opening tool.
    • Carefully pry off the 3D Sync Transmitter with the plastic opening tool.

    • Use the plastic opening tool to pry at both ends and not from the center as to avoid breaking the 3D Sync Transmitter.

  7. Pry the tab slightly up with your thumbnail and pull the connector away from the board. Pry the tab slightly up with your thumbnail and pull the connector away from the board.
    • Pry the tab slightly up with your thumbnail and pull the connector away from the board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 2 persone hanno completato questa guida.

Tia McNaughton

Membro da: 01/10/2015

379 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 12-16, Maness Fall 2015 Membro di Cal Poly, Team 12-16, Maness Fall 2015

CPSU-MANESS-F15S12G16

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 21

Tutti i Tempi: 1,357