Introduzione

The LED's, of the Solio Rocsta, are important to convey information. If your LEDs are burnt out, and no longer displaying light, we will show you how to replace them in this guide.

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.
  • Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

Aggiungi Commento

Remove top cover.
  • Remove top cover.

  • Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire .

Aggiungi Commento

  • Using the spudger, pry the battery off the back cover.

Aggiungi Commento

  • Using a T6 Torx screwdriver, unscrew the 5.66 mm screws attaching the circuit board to the case and flip the circuit board.

Aggiungi Commento

  • With the circuit board flipped, locate the battery connector.

  • Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

Aggiungi Commento

  • Using a T6 Torx screwdriver, unscrew the 5.66 mm screws attaching the circuit board to the case.

Aggiungi Commento

  • Flip the circuit board to be able to see where the LEDs are soldered to.

  • With a Soldering Iron, desolder the LEDs’ connectors.

  • For more information on how to solder and desolder connections, please visit this guide.

Aggiungi Commento

  • Gently pry the LEDs using one of the Precision Tweezers.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

David Vazquez

Membro da: 10/10/2017

529 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S13-G13, Cagle Fall 2017 Membro di USF Tampa, Team S13-G13, Cagle Fall 2017

USFT-CAGLE-F17S13G13

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 2

Tutti i Tempi: 47