Introduzione

The Solio Rocsta's charging cable is the main connection for charging/using your device. In this guide, we will show you how to replace your charging cable if it no longer works or needs repairing.

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.
  • Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

Aggiungi Commento

Remove top cover.
  • Remove top cover.

  • Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire.

Aggiungi Commento

  • Using the spudger, pry the battery off the back cover.

Aggiungi Commento

  • Unscrew the 5.66 mm screws attaching the circuit board to the case.

Aggiungi Commento

  • With the circuit board flipped, locate the battery connector.

  • Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

Aggiungi Commento

  • With a Soldering Iron, desolder the four cables that connect the charging cable to the circuit board.

    • The power cable is a series of four cables. Make note of each cable placement for easy resoldering.

    • For more information on how to solder and desolder connections, please visit this guide.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

David Vazquez

Membro da: 10/10/2017

529 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S13-G13, Cagle Fall 2017 Membro di USF Tampa, Team S13-G13, Cagle Fall 2017

USFT-CAGLE-F17S13G13

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 45