Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back panel by inserting your fingers into the indentations next to the tabs. Press the tabs inward towards each other while pulling the back panel toward you.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the T10 Torx Security Bit Screwdriver, unscrew the screws on the upper left and right corners of the inner panel to remove the inner back panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press down on the two plastic hinges to remove the upper portion of printer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the plastic plug on the end of the speaker wire, then gently pull the plug away from the printer until the wire is removed.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Rotate the printer so the paper tray is facing towards you.
-
Gently lift the scanner tray up and away from the printer.
-
Press the gray plastic tabs inward to release the tabs from the printer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Returning to the back of the printer, remove the scanner from the back hinges.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently grasp and unplug the two white ribbon cables from the printer body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Unplug the white plastic multi-wire connector (with orange, black, red, and brown wires) from it's port.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Detach the scanner tray from the printer by lifting the scanner tray off the printer body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Detach the white ribbon wire from the scanner head by pulling gently at the connection.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the gray drive belt from the black tab to disconnect the drive belt from the scanner head.
-
Remove the scanner head from the scanner by gently rotating and then lifting.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the new scanner head in the scanner tray by fastening the drive belt into the black tab.
-
Once the drive belt is secured, rotate the scanner head back into position.
-
Re-attach the white ribbon wire to the connection from Step 10.
-
Annulla: non ho completato questa guida.
Altre 3 persone hanno completato questa guida.
2 Commenti
Ok, but where do I purchase a new scanner head???
the step between 9 and 10 doesn't seem to make sense. it never established that the scanner head is broken...I couldn't identify where step 10 scanner head came up ...no where did it show the scanner between step 1 and step 9...Please offer an explanation...
by step 9 the scanner package had already removed...i m afraid I wont here from ifixit because the printer is about 20 years old.