Aggiusta la tua roba Comunità Store

Samsung Galaxy Tab 4 10.1 Home Button Replacement

Introduzione

Replacement guide for the home button on a Samsung Galaxy Tab 4 10.1 android tablet.

Cosa ti serve

  1. Samsung Galaxy Tab 4 10.1 Home Button Replacement, Battery: passo 1, immagine 1 di 2 Samsung Galaxy Tab 4 10.1 Home Button Replacement, Battery: passo 1, immagine 2 di 2

    • Insert the wedge of the nylon spudger and slide it between the front and back panels until the back comes off.

    Modifica

  2. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 2, immagine 1 di 1

    • Peel off the green tape that covers the connectors for the three black strips.

    • Use the tip of a spudger or your fingernail to flip up the small retaining flaps.

    Modifica

  3. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 3, immagine 1 di 1

    • Use a Phillips #00 screwdriver to remove the four 3.2mm screws.

    Modifica

  4. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 4, immagine 1 di 1

    • Detach the red, blue, and black cables by prying up on the white connector from the motherboard.

    • If using fingers instead, pull evenly on the full width of the cable so the wires are not overly strained.

    • If you pull too hard you can damage the connector on the circuit board. Use a spudger or tweezers to push down on the black connector on the board while gently prying the battery connector loose. The connector breaks VERY easily.

    Modifica

  6. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 5, immagine 1 di 1

    • Use the nylon spudger to remove the battery by prying up on the edges.

    Modifica

  7. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 6, immagine 1 di 1

    • Once the battery is loose, lift it out of the device.

    Modifica

  8. Samsung Galaxy Tab 4 10.1 Home Button Replacement, Digitizer: passo 7, immagine 1 di 1

    • Use the flat end of a spudger to disconnect the home button.

    Modifica

  9. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 8, immagine 1 di 1

    • Use an iOpener to weaken the adhesive around the display.

    Modifica

  10. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 9, immagine 1 di 1

    • Wedge an opening pick between the digitizer and display frame.

    • Slide the opening pick around the perimeter to separate the two pieces.

    Modifica

  11. Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 10, immagine 1 di 2 Samsung Galaxy Tab 4 10.1 Home Button Replacement: passo 10, immagine 2 di 2

    • Lift and remove the digitizer.

    Modifica

  12. Samsung Galaxy Tab 4 10.1 Home Button Replacement, Home Button: passo 11, immagine 1 di 2 Samsung Galaxy Tab 4 10.1 Home Button Replacement, Home Button: passo 11, immagine 2 di 2

    • Lay the digitizer face down and remove the home button ribbon cable.

    • Remove the exterior home button.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Autore

Blake Klein

Membro da: 01/29/17

70.510 Reputazione

50 Guide realizzate

Distintivi: 43

+40 altri distintivi

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 20

Tutti i Tempi: 3,709