Introduzione

This guide will teach you how to remove and replace the motherboard in the Samsung Galaxy S7 Active.

Melt the adhesive on the screen by applying a blow dryer directly on the screen.
  • Melt the adhesive on the screen by applying a blow dryer directly on the screen.

  • Your phone is hot, please do not touch it with your bare hand.

Aggiungi Commento

Wedge the metal spudger in between the screen and the frame to begin separating them.
  • Wedge the metal spudger in between the screen and the frame to begin separating them.

  • It would be easier to separate the screen from the sealing adhesive on the frame if you with more than one metal spudger.

  • Your phone might no longer be watertight after you reassemble it.

Aggiungi Commento

  • Slide the metal spudger around the phone at least once.

  • It would be easier to slide your metal spudger if you apply the blow dryer to where you are currently sliding.

Aggiungi Commento

  • Lift the screen up with your hands.

  • Please wash your hands thoroughly with hot water and soap after you finish.

Aggiungi Commento

  • Use a Phillips #000 screwdriver to remove a single screw.

Aggiungi Commento

  • Use tweezers to remove the small plastic cover you just unscrewed.

Aggiungi Commento

  • Use tweezers to remove the other small plastic cover.

Aggiungi Commento

  • Use a Phillips head #000 to take out the eleven screws marked in the photo.

Aggiungi Commento

  • Use tweezers to disconnect the marked pieces from the motherboard.

Aggiungi Commento

  • Use tweezers to take out the middle button and its connection to the motherboard.

Aggiungi Commento

  • Use a metal spudger to pull the mid frame and battery off of the motherboard.

Aggiungi Commento

  • Use a metal spudger to remove the battery from the midframe.

Aggiungi Commento

  • Use tweezers to disconnect the front camera from the battery.

  • The connector should unsnap similar to a lego piece.

Aggiungi Commento

  • Use a Phillips 000 screwdriver to remove the screw covering the proximity sensor.

Aggiungi Commento

  • Use tweezers to remove the proximity sensor.

  • Set this aside for now.

Aggiungi Commento

  • Use tweezers to disconnect the front mic and the two cables that have been marked in the photo.

Aggiungi Commento

  • Use your hands and a metal spudger to lift the motherboard out of the phone.

  • Be gentle, as there is still a connection on the underside of the motherboard.

  • Use a metal spudger to remove this connection.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Joe De Leone

Membro da: 18/04/2018

253 Reputazione

3 Guide realizzate

Team

Cal Poly, Team S18-G1, Livingston Spring 2018 Membro di Cal Poly, Team S18-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G1

4 Membri

14 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 2

Ultimi 7 Giorni: 15

Ultimi 30 Giorni: 84

Tutti i Tempi: 322