Introduzione

This guide will show you how to replace the Samsung Galaxy S7 Active front camera.

  1. Melt the adhesive on the screen by applying a blow dryer directly on the screen.
    • Melt the adhesive on the screen by applying a blow dryer directly on the screen.

    • Your phone is hot, please do not touch it with your bare hand.

  2. Wedge the metal spudger in between the screen and the frame to begin separating them.
    • Wedge the metal spudger in between the screen and the frame to begin separating them.

    • It would be easier to separate the screen from the sealing adhesive on the frame if you with more than one metal spudger.

    • Your phone might no longer be watertight after you reassemble it.

    • Slide the metal spudger around the phone at least once.

    • It would be easier to slide your metal spudger if you apply the blow dryer to where you are currently sliding.

    • Lift the screen up with your hands.

    • Please wash your hands thoroughly with hot water and soap after you finish.

    • Use a Phillips #000 screwdriver to remove a single screw.

    • Use tweezers to remove the small plastic cover you just unscrewed.

    • Use tweezers to remove the other small plastic cover.

    • Use a Phillips head #000 to take out the eleven screws marked in the photo.

    • Use tweezers to disconnect the marked pieces from the motherboard.

    • Use tweezers to take out the middle button and its connection to the motherboard.

    • Use a metal spudger to pull the mid frame and battery off of the motherboard.

    • Use a metal spudger to remove the battery from the midframe.

    • Use tweezers to disconnect the front camera from the battery.

    • The connector should unsnap similar to a lego piece.

    • Use a Phillips 000 screwdriver to remove the screw covering the proximity sensor.

    • Use tweezers to remove the proximity sensor.

    • Set this aside for now.

    • Use tweezers to disconnect the front mic and the two cables that have been marked in the photo.

    • Use your hands and a metal spudger to lift the motherboard out of the phone.

    • Be gentle, as there is still a connection on the underside of the motherboard.

    • Use a metal spudger to remove this connection.

    • Use tweezers to remove the connection between the motherboard and the front camera.

    • In order to do this, the motherboard must be flipped over from its original position.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team S18-G1, Livingston Spring 2018 Membro di Cal Poly, Team S18-G1, Livingston Spring 2018

CPSU-LIVINGSTON-S18S18G1

4 Membri

14 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 8

Ultimi 30 Giorni: 28

Tutti i Tempi: 167