Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
You will need two screwdrivers:
-
a 6.5mm flathead and
-
a small Phillips #1.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take the flathead screwdriver.
-
Insert it into the slot located at the bottom of the handle and turn counterclockwise to release the bottom cap.
-
The second image shows the amount of turning needed to loosen the bottom cap.
-
Hold the handle upside down, and push down on the shaft to release the internal components of the handle.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully pull the internals out of the casing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Take the small Phillips screwdriver.
-
Tighten the small screw that can be found near the top of the device internals
-
Hence, unscrew the screw completely and put some superglue at the end of it. Then tighten it again. This prevents the screw to get loose due to the vibrations.
-
Annulla: non ho completato questa guida.
Altre 12 persone hanno completato questa guida.
7 Commenti
thanks for that one - you rescued ours from a premature trip to the landfill :)
Excellent guide; a simple fix saves $$ and waste. Thanks!!
Thank you! It's realy help me!