Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the eight screws holding the wood-patterned cover to the microwave frame.
-
The first four screws are located on either side of the microwave front.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the additional four screws securing the wood-paneled case to the microwave frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Placing your hands on either side of the case, slide the case back gently until you feel it completely separate from the microwave frame.
-
Lift the case upward slowly until the case is free of the microwave.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The capacitor stores a small amount of electrical energy. Discharge capacitor by placing a screw driver across the terminals. Use a screwdriver with a non-metallic handle and a shaft that is longer than 4” (10.75mm) Touch the metal shaft of the screwdriver simultaneously to both metal terminals of the capacitor. There should be a spark.
-
If the capacitor sparks, you can stop reading here. The spark indicates that the capacitor is working properly. If the capacitor does not spark, read on to Step 6.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Place the multimeter on resistance mode and test the resistance of the capacitor.
-
If the resistance increases/decreases, the capacitor is working fine. If the resistance of the capacitor reads 0 or over several kilo ohms, the capacitor needs to be replaced.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Tip the microwave back so it is lying face up. This allows access to the screws beneath the transformer.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Locate the transformer. The capacitor cannot be removed without removing the transformer first.
-
Locate and unhook all wires connecting the transformer to the rest of the microwave.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four exterior screws securing the transformer to the microwave frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
The metal band locking the capacitor in place can now be accessed. Locate and remove the screw securing the the metal band.
-
Lift the metal band off the capacitor.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
You can now install a replacement capacitor.
-
Repeat all steps in reverse order to install a capacitor in a Quasar Microwave MQ7774XW (1984).
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.