Aggiusta la tua roba Comunità Store

Protocol TerraCopter EVO Drone Motor Replacement

Cosa ti serve

  1. Protocol TerraCopter EVO Drone Motor Replacement, Drone Motor: passo 1, immagine 1 di 1

    • Orientate the drone to where the black side of the drone face upwards.

    • On the bottom side of the drone, remove the twenty-two 5mm Phillips #1 screws holding the black frame to the body.

    • There is one screw under the rear light. Pry the opaque cover to access the last screw.

    Modifica

  2. Protocol TerraCopter EVO Drone Motor Replacement: passo 2, immagine 1 di 1

    • The plastic frames are subject to cracking.

    • Wires run through both frames.

    • Pry the white body away from the black frame.

    Modifica

  4. Protocol TerraCopter EVO Drone Motor Replacement: passo 3, immagine 1 di 1

    • Gently pry the motor from it's socket.

    Modifica

  5. Protocol TerraCopter EVO Drone Motor Replacement: passo 4, immagine 1 di 2 Protocol TerraCopter EVO Drone Motor Replacement: passo 4, immagine 2 di 2

    • Locate these solder points of the leads on the motherboard.

    • From the front of the drone, the left motor has red and blue leads.

    • From the front of the drone, the right motor has white and black leads.

    • Remove the leads from their points on the motherboard with a soldering iron, respective to each motor.

    • Check out our How to Solder and Desolder Connections guide if you are unfamiliar with soldering practices.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 189