Introduzione

This guide shows you how to replace the motors on your drone. Soldering is a skill required for this task. Replacement motors can be found on the manufacturer's website.

  1. Remove the four blades by pulling them off of the motors. Remove the four blades by pulling them off of the motors.
    • Remove the four blades by pulling them off of the motors.

  2. Remove the blade guards by pushing the guards downward towards the padded feet.
    • Remove the blade guards by pushing the guards downward towards the padded feet.

  3. Spedizione gratuita per tutti gli ordini superiori a 100 US$ o contenenti un Kit Attrezzi Pro Tech!

    Sfoglia il Nostro Negozio
  4. Remove the four 4.5mm Phillips #0 screws from the back panel.
    • Remove the four 4.5mm Phillips #0 screws from the back panel.

  5. Use the flat end of a spudger to pry apart the the two pieces. Lift the back panel up to separate it from the front panel.
    • Use the flat end of a spudger to pry apart the the two pieces.

    • Lift the back panel up to separate it from the front panel.

  6. Pull the four motors out of the case.
    • Pull the four motors out of the case.

    • The motors are still soldered to the motherboard.

  7. Here is a link to the iFixit Soldering Guide
    • Here is a link to the iFixit Soldering Guide

    • Use a soldering iron to desolder the motors from the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Andrew

Membro da: 05/07/2018

291 Reputazione

2 Guide realizzate

Team

IUPUI, Team S2-G3, Harley Summer 2018 Membro di IUPUI, Team S2-G3, Harley Summer 2018

IUPUI-HARLEY-SU18S2G3

4 Membri

2 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 1

Tutti i Tempi: 153