Salta al contenuto principale

Protocol Neo-Drone AP Controller Switch Replacement

Cosa ti serve

  1. Protocol Neo-Drone AP Controller Switch Replacement, Controller Switch: passo 1, immagine 1 di 2 Protocol Neo-Drone AP Controller Switch Replacement, Controller Switch: passo 1, immagine 2 di 2
    • Remove the single 6.5mm Phillips #1 screw from the battery cover.

    • Remove the three AAA batteries.

  2. Protocol Neo-Drone AP Controller Switch Replacement: passo 2, immagine 1 di 2 Protocol Neo-Drone AP Controller Switch Replacement: passo 2, immagine 2 di 2
    • Remove seven 6.5mm Phillips #1 screws from the back panel.

    • Pull the back panel up to separate it from the front panel.

  3. Protocol Neo-Drone AP Controller Switch Replacement: passo 3, immagine 1 di 2 Protocol Neo-Drone AP Controller Switch Replacement: passo 3, immagine 2 di 2
    • Remove three 4.5mm Phillips #1 screws from the motherboard.

    • Pull the motherboard out of the case.

  4. Protocol Neo-Drone AP Controller Switch Replacement: passo 4, immagine 1 di 2 Protocol Neo-Drone AP Controller Switch Replacement: passo 4, immagine 2 di 2
    • Here is a link to the iFixit Soldering Guide

    • Use a soldering iron to remove the solder form the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Andrew

Membro da: 07/05/18

291 Reputazione

2 Guide realizzate

Team

IUPUI, Team S2-G3, Harley Summer 2018 Membro di IUPUI, Team S2-G3, Harley Summer 2018

IUPUI-HARLEY-SU18S2G3

4 Membri

2 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 219