Introduzione

Use this guide to replace your headset's motherboard

  1. Flip the headset face down.
    • Flip the headset face down.

    • Squeeze both sides of the battery cover.

    • While squeezing, pull the cover up slowly to remove it.

  2. Locate and detatch the white connector that connects the wires of the battery to the wires of the headset.
    • Locate and detatch the white connector that connects the wires of the battery to the wires of the headset.

    • Use a hairdryer or heat gun to melt the adhesive along the crevice that joins the black and silver components.

    • Apply additional heat at the tip of the microphone.

    • After heating the headset, use the plastic opening tool to carefully pry the black cover from the headset.

    • Be aware of the two plastic connectors inside the headset. If the black cover does not come off smoothly, apply additional heat on the connectors.

    • Remove the microphone from the tip of the plastic.

    • You will have to lift the microphone straight up because it is held in place by a small piece of plastic.

    • Use the heat gun to melt the adhesive connecting the headset face to the speaker casing.

    • Use the plastic opening tool to separate the speaker casing from the headset face.

    • Add extra heat to the sides to melt the adhesive between the plastic connectors.

    • Slowly separate the motherboard from the rest of the headset.

    • Locate the microphone wires on the bottom of the motherboard.

    • Use a hairdryer or heat gun to melt the glue off of the motherboard.

    • Flip the device over.

    • Use a soldering iron to remove the solder that holds the wires to the motherboard.

    • For help soldering, click here.

    • The microphone piece should be completely detached from the motherboard.

    • Using a blow dryer or a heat gun, heat the crevice to melt the adhesive between the plastic covers.

    • Using a plastic opening tool, prop open the edges.

    • Gently pull the black speaker casing up to remove it.

    • Use the heat gun or blow dryer to melt the glue that connects the wires to the headset's motherboard.

    • The wires should come off as they are not soldered to the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Joe

Membro da: 12/04/2012

91 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 17-29, Amido Spring 2012 Membro di Cal Poly, Team 17-29, Amido Spring 2012

CPSU-AMIDO-S12S17G29

4 Membri

7 Guide realizzate

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 747