Introduzione

This guide will teach users how to replace broken or malfunctioning lens assembly.

  1. Remove the battery and the SD Card
    • Remove the battery and the SD Card

    Aggiungi Commento

  2. Unscrew the two bottom 1.0 mm screws with a Phillips #000 screwdriver
    • Unscrew the two bottom 1.0 mm screws with a Phillips #000 screwdriver

    • Unscrew the two 1.0 mm screws to the left with a Phillips #000 screwdriver

    • Unscrew the two 1.0 mm screws to the right with a Phillips #000 screwdriver

    Aggiungi Commento

    • Carefully separate the back of the camera from the main body

    • Do not apply excessive force. The LCD is connected by ribbon cables that can be easily damaged

    Aggiungi Commento

    • Use the tip of the 2.0 mm flathead screwdriver to flip up the black tabs on the ribbon cables

    • Pull gently on the ribbon cables to unseat them

    Aggiungi Commento

    • Unscrew the two 1.0 mm screws to the left with a Phillips #000 screwdriver

    • Unscrew the two 1.0 mm screws to the right with a Phillips #000 screwdriver

    • Unscrew the two bottom 1.0 mm screws with a Phillips #000 screwdriver

    Aggiungi Commento

    • Carefully separate the front of the camera from the main body

    Aggiungi Commento

    • Use the tip of the 1.5 mm flathead screwdriver to disengage the plastic tab

    • Carefully lift the selector switch away from the motherboard

    Aggiungi Commento

    • Unscrew the three silver 1.0 mm screws with a Phillips #000 screwdriver

    • Use the tip of the 2.0 mm flathead to disengage the metal tab, then carefully lift the shield away from the motherboard

    Aggiungi Commento

    • Insert the tip of the 2.0 mm flathead into the center hole of the tripod mount, and apply force in the direction facing away from the button

    • Carefully lift the tripod mount out of the camera body

    Aggiungi Commento

    • Use the 2.0 mm flathead to flip up the brown tab on the motherboard and carefully unseat the ribbon cable

    • Insert the tip of the 2.0 mm flathead screwdriver into the hole on the daughter board, then apply upward force to remove the daughter board from the main case

    Aggiungi Commento

    • Use the 2.0 mm flathead to flip up the two tabs on the motherboard and carefully unseat the ribbon cables

    • Unscrew the three silver 1.0 mm screws with a Phillips #000 screwdriver

    • Carefully lift the lens assembly out of the camera

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Derrick Thompson

Membro da: 30/01/2018

1.035 Reputazione

5 Guide realizzate

Team

Baylor, Team S2-G5, Johnson Spring 2018 Membro di Baylor, Team S2-G5, Johnson Spring 2018

BU-JOHNSON-S18S2G5

3 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 76