Introduzione

This guide shows you how to take off the back panel to the Palm Treo 680 in order to reach the other components within side the phone.

Remove the battery cover by pressing on the small rectangular button location the back of the phone.
  • Remove the battery cover by pressing on the small rectangular button location the back of the phone.

Aggiungi Commento

Remove the battery by pulling it out toward you.
  • Remove the battery by pulling it out toward you.

Aggiungi Commento

  • Unscrew the 0.266 inch top-left screw with a T6 Torx Screwdriver.

  • Be sure to remove the stylus in order to access the screw.

Use a T5 Torx screwdriver instead of a T6. T6 is too big.

Rhebakah Thomas - Replica

I found T5 too large as well. T4 seeems to work

Absent Minded Professor - Replica

  • Using the spudger, remove the rubber rectangular cover located in the upper right hand side of the device.

  • Unscrew the 0.266 inch screw with the T6 Torx Screwdriver.

    • If there is a red Palm sticker covering the screw, just puncture it to access the screw.

Aggiungi Commento

  • Remove the remaining two 0.266 inch screws at the bottom of the device.

Aggiungi Commento

  • Turn the phone 90 degrees to the right, so the screen is facing the right side.

  • Use a spudger to carefully separate the back panel from the front panel to access all the various components inside the phone.

  • Separate the covers from the left side of the device as indicated in the picture. The right side contains orange ribbons that are easily damaged.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Maiya123

Membro da: 22/10/2009

36 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 6-4, Maness Fall 2009 Membro di Cal Poly, Team 6-4, Maness Fall 2009

CPSU-MANESS-F09S6G4

4 Membri

12 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 11

Tutti i Tempi: 2,709