Introduzione

Guide for removing the power jack from a Sony PSP-3000

  1. Place the PSP face down and locate the battery cover on the left side of the device.
    • Place the PSP face down and locate the battery cover on the left side of the device.

    • Lift and remove the battery cover to reveal the battery.

    • Remove the battery.

    Aggiungi Commento

  2. Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.
    • Peel back the warranty sticker that is behind the battery with a spudger or your fingernail.

    Aggiungi Commento

    • Unscrew all four screws from the back of the PSP with the Phillips #00 Screwdriver.

      • Two are located behind the battery's warranty sticker.

      • Two are located on the right side of the PSP.

    Aggiungi Commento

    • Next, unscrew the two screws located at the top of the PSP.

    Aggiungi Commento

    • Then, remove the single screw from the bottom edge of the PSP (which is positioned next to the barcode).

    Aggiungi Commento

  3. Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    Diffondi allegria Fixmas
    Ottieni $12 sul tuo acquisto di $50 o più con il codice FIXMAS12
    • Slide the spudger in between the outer casing of the PSP, beginning at the "R" shoulder button, and gently pry off the casing.


    • Remove the front casing completely.

    Aggiungi Commento

    • Push the homebar to the right to release the tab located on the right side of the LCD screen.

    • DO NOT completely remove the homebar, as it is still connected by ribbon cables.

    Aggiungi Commento

    • Slowly lift the LCD screen off the PSP starting at the top edge corner.

    • Again, the LCD screen is attached by ribbon cables, so do not remove it completely.

      • Orientation of PSP is flipped in photo.

    Aggiungi Commento

    • Flip the small brown locks on the four ribbon cable connectors up using a spudger or fingernail.

    • Pull all four ribbon cables out.

    • Now remove the LCD screen and homebar from the PSP.

    For anyone struggling to get the screen’s smaller ribbon cable back in, don’t be too afraid to use tweezers to pull on the little tabs. It has to go in a good half way (of the darker area) in order for you to latch it without it falling back out.

    Tom - Replica

    • Remove the metal tab that lies above the LCD screen.

    • Upon reassembly, make note that the stamped lettering faces down, and the large tab fits just above the motherboard to the right hand side of the left trigger.

    Aggiungi Commento

    • Flip up the lock and detach the ribbon cable above the power jack.

    Aggiungi Commento

    • Remove the screw from the power jack.

    Aggiungi Commento

    • Carefully bend back the black tab holding the power jack in place and start pulling the jack up to release it from this clip.

    Aggiungi Commento

    • Pull the plug connecting the power jack to the motherboard.

    • Remove the power jack.

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 7 persone hanno completato questa guida.

mbnewsom

Membro da: 28/10/2009

2.420 Reputazione

11 Guide realizzate

Really easy to follow, thanks. You can dismiss the 10 and 11 steps being careful.

aONe - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 5

Ultimi 30 Giorni: 53

Tutti i Tempi: 11,767