Salta al contenuto principale

Cosa ti serve

  1. OnePlus 6 Lower Frame Replacement, Back Panel: passo 1, immagine 1 di 1
    • Turn on the heat gun to a low heat and and gently heat the curved edges on the back of the phone.

    • Be careful not to overheat or melt the plastic; heat guns can get out of hand quickly!

    • Wedge the opening picks between the front and back panel and slide them around the perimeter to break the adhesive securing the back cover.

    • Repeat until the back panel is fully released.

  2. OnePlus 6 Lower Frame Replacement: passo 2, immagine 1 di 2 OnePlus 6 Lower Frame Replacement: passo 2, immagine 2 di 2
    • Gently lift up the back panel, with care not to damage the fingerprint sensor ribbon cable.

  3. OnePlus 6 Lower Frame Replacement: passo 3, immagine 1 di 2 OnePlus 6 Lower Frame Replacement: passo 3, immagine 2 di 2
    • Use a pair of tweezers to gently pull up on the red tab and disconnect the cable from the device.

    • Completely remove the back panel from the device.

  4. OnePlus 6 Lower Frame Replacement, Lower Frame: passo 4, immagine 1 di 2 OnePlus 6 Lower Frame Replacement, Lower Frame: passo 4, immagine 2 di 2
    • Using the Phillips #00 screwdriver, remove the eight 3 mm screws from the lower frame.

    • Gently lift the lower panel up and out of the device.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Team

Clemson, Team 4-3, Hunter Fall 2021 Membro di Clemson, Team 4-3, Hunter Fall 2021

CLEM-HUNTER-F21S4G3

5 Membri

12 Guide realizzate

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 6

Ultimi 30 Giorni: 17

Tutti i Tempi: 283