Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the Numark N4 over so that the bottom panel is facing upwards.
-
Loosen and remove the 17 12mm screws from the bottom panel using a Phillips #2 screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, gently pull apart the two panels of the device until you feel resistance from the cables.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, gently unplug the larger ribbon cable as pictured.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, gently unplug the smaller ribbon cable as pictured.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using your fingers, gently unplug the yellow and red cable as pictured.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open the two panels completely, gently placing each side on your working area to avoid damage to the buttons on the outside face.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the panel around so that the audio jack is facing forward as shown.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a soldering station, carefully desolder the connection points around the audio jack and remove it.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.