Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Svita le quattro viti a croce Phillips #00 lungo il bordo superiore della cover posteriore.
-
-
-
Infila uno strumento di apertura in plastica nella fessura nella scocca inferiore sopra la batteria.
-
Fai leva con lo strumento di apertura in plastica per sollevare la batteria.
-
Afferra il bordo superiore della batteria e sollevalo dalla scocca inferiore.
-
-
-
Svita le nove viti a croce Phillips nere da 6,3 mm sulla scocca inferiore.
-
Svita la vite a croce Phillips cromata da 2,4 mm sopra il lettore delle cartucce di gioco.
-
-
-
Svita le due viti a croce Phillips da 7,7 mm che fissano il retro della levetta analogica alla scheda madre.
-
-
-
Svita le due viti a croce Phillips da 4,5 mm che fissano la scheda del lettore SD alla scheda madre.
-
-
-
-
Infila la parte piatta di uno spudger sotto un angolo della scheda WiFi e solleva la scheda dalla scheda madre.
-
-
-
Afferra il cavo a nastro del microfono con un paio di pinzette vicno al microfono stesso.
-
Tira il microfono verso l'alto per sfilarlo dalla scocca superiore.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the tip of a spudger or your fingers to peel back the white tape covering the touchscreen ribbon cable connector.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger or your fingernail to flip up the retaining flap on the touchscreen ribbon cable ZIF socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger or your fingernail to flip up the retaining flap on the lower LCD power ribbon cable ZIF socket.
-
Pull the ribbon cable out of the connector with a pair of tweezers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger or your fingernail to flip up the retaining flap on the lower LCD data ribbon cable ZIF socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Grasp the lower display assembly and pull it directly away from the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Starting at the bottom right corner, insert the flat end of a spudger between the touchscreen and LCD frame and gently pry the touchscreen off the LCD.
-
Insert the spudger into the top right corner between the two pieces and pry the touchscreen off the LCD frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Repeat the above procedure for the remaining two corners to pry the touchscreen off the LCD frame.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Gently lift the touchscreen up to completely separate it from the lower LCD.
-
Annulla: non ho completato questa guida.
Altre 10 persone hanno completato questa guida.