Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Con l'accessorio per l'estrazione della scheda SIM (anche una graffetta funzionerà), premi verso il basso nel foro nella parte superiore del dispositivo finché non verrà rilasciato l'alloggiamento della scheda SIM. Questo non dovrebbe richiedere una forte pressione.
-
Rimuovi la scheda SIM ed il suo alloggiamento.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:iOpener$12.99-
Lay out a soft cloth on your workspace to prevent scratching the screen in this and future steps.
-
Pry open the back casing using the soft plastic opening pick.
-
Carefully pull the back casing apart from the rest of the phone with your hands. Because the casing is glued to the rest of the phone, this step may require some force. Don't be alarmed if the casing flexes a bit.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the twenty-two 2.3 mm T3 Torx screws with the T3 Torx Screwdriver.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With tweezers, remove the rubber protector on the lower part of the phone.
-
Disconnect the battery connector by gently prying it straight up with a spudger, on the side opposite the cable.
-
Completely separate the battery side from the motherboard side by gently pulling the sides apart with your hands.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to gently detach the front facing camera connector.
-
Remove the front facing camera using the tweezers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the spudger to release the rear facing camera connector.
-
Use tweezers to gently remove the rear facing camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With a spudger, unlatch the ZIF connector for the smallest ribbon cable in the center. See instructions for detatching ZIF connectors here
-
Use tweezers to release the ribbon cable.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With a spudger, unlatch the ZIF connector of the big ribbon cable on the side of the phone. See instructions for detatching ZIF connectors here.
-
Use tweezers to release the ribbon cable completely.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 2.3 mm T3 Torx screw on the top of the phone.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel the motherboard off of the screen with your hands.
-
Annulla: non ho completato questa guida.
Altre 13 persone hanno completato questa guida.