Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Make sure the headphones are off and unplugged from any devices.
-
Remove leather headphone cushion by pulling edge towards middle of headphone.
-
It should slip off the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully peel back foam pad to prevent tearing.
-
It is glued at both the top and bottom.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the T6 torx screwdriver to remove the three screws holding the speaker in place.
-
To avoid stripping screws, be sure to use the right screw bit oriented perpendicular to the face of the screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.
-
Solder wires onto corresponding pads of replacement speaker.
-
For soldering see the ifixit soldering guide: Come saldare e dissaldare componenti elettrici
-