Difficoltà
Difficile
Passi
4
Tempo Necessario
- Headphone Speaker 4 passi
Inconveniente Markup
Questa guida ha bisogno di markup migliori. Contribuisci correggendoli o con annotazioni sui markup.
Dettagli Mancanti
Alcuni dettagli di questa guida sono mancanti. Aiuta gli utenti aggiungendo strumenti, livello di difficoltà o tempo di esecuzione.
Introduzione
Before proceeding with the replacement guide, please ensure the headphones are unplugged from any device.
-
Remove leather headphone cushion by pulling edge towards middle of headphone.
-
It should slip off the device.
-
Carefully peel back foam pad to prevent tearing.
-
It is glued at both the top and bottom.
-
Use the T6 torx screwdriver to remove the three screws holding the speaker in place.
-
To avoid stripping screws, be sure to use the right screw bit oriented perpendicular to the face of the screw.
-
With the speaker removed from the speaker module, clip the black and white wires on the back of the speaker, as shown.
-
Solder wires onto corresponding pads of replacement speaker.
-
For soldering see the ifixit soldering guide: How To Solder and Desolder Connections
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Team
Michigan Tech, Team 5-1, Lauer Spring 2014 Membro di Michigan Tech, Team 5-1, Lauer Spring 2014
MTU-LAUER-S14S5G1
2 Membri
3 Guide realizzate
