Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
-
Usa uno spudger per ruotare verso l'alto le piccole alette di bloccaggio dei connettori ZIF del cavo dello schermo.
-
-
-
Infila un plettro sotto la scheda dello schermo per separare l'adesivo che la fissa sul retro dello schermo.
-
-
-
Inserisci una punta di un paio di pinzette appuntite in una fessura nell'angolo dello schermo EMI che copre il dissipatore di calore.
-
Usa le pinzette per staccare lo schermo EMI dalla scheda madre il più possibile senza piegarlo. Non rimuoverlo ancora.
-
-
-
-
Rimuovi le dieci viti Torx che fissano il dissipatore di calore:
-
Cinque viti T3 lunghe 2,6 mm
-
Quattro viti T5 lunghe 3,3 mm
-
Vite 1
-
Vite 2
-
Vite 3
-
Vite 4
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the Torx T5 x 6mm screw connecting the black tie bar to the power button/volume control/speaker assembly.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the remaining three Torx T5 x 4.5mm screws holding down the camera tie bar.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
Attrezzo utilizzato in questo passaggio:Tweezers$4.99-
Disconnect the small ribbon cable connecting the camera tie bar to the motherboard by pulling up with tweezers.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry off the metal cover covering the front and rear camera ribbon cable motherboard connections using a nylon spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the front camera ribbon cable off the motherboard using the nylon spudger.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two Torx T3 x 2.5mm screws holding down the rear camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Lift the rear camera ribbon cable off the motherboard using the nylon spudger.
-
Annulla: non ho completato questa guida.
Un'altra persona ha completato questa guida.
Un commento
In step 19, there is a loose, clear plastic piece next to the front camera. In my disassembly, that piece managed to get lost. Can anyone tell me what the name of that part is, and where I can get one?