Aggiusta la tua roba Comunità Store

MerchSource the Black Series Boat Racer Battery Cable Replacement

Introduzione

This repair guide will show you how to replace the cable that connects the positive battery terminal to the circuit board within the remote controller for the MerchSource the Black Boat Series Boat Racers Device.

Cosa ti serve

  1. MerchSource the Black Series Boat Racer Battery Cable Replacement, Battery Cable: passo 1, immagine 1 di 2 MerchSource the Black Series Boat Racer Battery Cable Replacement, Battery Cable: passo 1, immagine 2 di 2

    • Turn the remote controller over to the back.

    Modifica

  2. MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 2, immagine 1 di 1

    • Slide the battery cover off.

    Modifica

  4. MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 3, immagine 1 di 2 MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 3, immagine 2 di 2

    • Remove both AA-batteries.

    Modifica

  5. MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 4, immagine 1 di 1

    • Use a Phillips #1 screwdriver, remove the four screws located in the four corners of the back of the remote controller.

    • Screw length is 6 mm.

    Modifica

  6. MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 5, immagine 1 di 3 MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 5, immagine 2 di 3 MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 5, immagine 3 di 3

    • Separate the two halves of the remote controller.

    Modifica

  7. MerchSource the Black Series Boat Racer Battery Cable Replacement: passo 6, immagine 1 di 1

    • Solder the wire to reconnect it.

    Modifica
Conclusione

To reassemble your device, follow these instructions in reverse order.

0 Commenti

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 5

Tutti i Tempi: 200