Questa traduzione potrebbe non riflettere gli aggiornamenti più recenti dalla guida originale. Aiuta ad aggiornare la traduzione o visualizza la guida d'origine.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger to pry the AirPort/Bluetooth cable connector up off the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the following screws securing the right speaker assembly to the upper case:
-
One 12 mm Phillips screw.
-
One 3 mm Phillips screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single 2.2 mm Phillips screw inserted horizontally into the side of the optical drive.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the AirPort and Bluetooth antenna connectors (3 total) up off the AirPort/Bluetooth card.
-
De-route the long antenna from its channel in the rear speaker housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use the flat end of a spudger to pry the rear speaker cable connector up off the logic board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the rear speaker assembly from the upper case.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Carefully peel the AirPort/Bluetooth cable from its channel within the rear speaker assembly.
-
Use the flat end of a spudger to pry the AirPort/Bluetooth cable up off the rear speaker.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove three 3 mm Phillips screws securing the AirPort/Bluetooth board to the rear speaker assembly.
-
Un ringraziamento speciale a questi traduttori:
7%
Massimo Martini ci sta aiutando ad aggiustare il mondo! Vuoi partecipare?
Inizia a tradurre ›