Introduzione

This guide explains how to re-attach the WiFi antenna.

  1. Remove the 5.0mm screw using the Phillips #0 head screwdriver.
    • Remove the 5.0mm screw using the Phillips #0 head screwdriver.

    Aggiungi Commento

  2. Insert metal spudger as shown in the picture. Move spudger along  to the other side until both snaps come loose.
    • Insert metal spudger as shown in the picture. Move spudger along to the other side until both snaps come loose.

    Aggiungi Commento

    • Picture shows the removed battery cover.

    Aggiungi Commento

    • Slide the battery out by pulling on one of two plastics tabs.

    Aggiungi Commento

    • Remove the remaining five 6.0 mm Phillips #0 screws.

    Aggiungi Commento

    • Use the spudger to remove the back cover. Insert the spudger between the back and front cover. Once inserted, you will need to move it around the perimeter to release the snaps holding it together.

    Aggiungi Commento

    • Once back cover is removed, the speaker wire will need to be removed. Use tweezers to remove wire.

    Aggiungi Commento

    • Begin by heating the exposed end of the grey lead with the tip of a soldering iron while simultaneously pulling the lead away from the connection, using tweezers to grasp the lead by the insulation.

    • For more information on soldering, check out this repair guide: iFixit Soldering

    Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Yancey Crase

Membro da: 26/03/2018

217 Reputazione

2 Guide realizzate

Team

IUPUI, Team S1-G4, Harley Spring 2018 Membro di IUPUI, Team S1-G4, Harley Spring 2018

IUPUI-HARLEY-S18S1G4

7 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 5

Tutti i Tempi: 60