Salta al contenuto principale

Introduzione

This guide requires soldering, for soldering guide click below.

Soldering Guide

  1. Use the  plastic opening tool to lift up the rubber pad. With your fingers, pull back the rubber pad. This will expose the screw holes on the bottom of the device.
    • Use the plastic opening tool to lift up the rubber pad.

    • With your fingers, pull back the rubber pad. This will expose the screw holes on the bottom of the device.

    • Repeat the step above for the second rubber pad on the bottom of the hub.

  2. Using the PH00 bit, remove the four 6mm Phillips screws Using the PH00 bit, remove the four 6mm Phillips screws
    • Using the PH00 bit, remove the four 6mm Phillips screws

  3. Use the plastic opening tool to pry open and separate the pieces of plastic from each other. Use the plastic opening tool to pry open and separate the pieces of plastic from each other.
    • Use the plastic opening tool to pry open and separate the pieces of plastic from each other.

  4. Using  the PH00 bit, remove the three 4mm Phillips screws. Using  the PH00 bit, remove the three 4mm Phillips screws.
    • Using the PH00 bit, remove the three 4mm Phillips screws.

  5. Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing. Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing. Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing.
    • Starting at the yellow corner, use a plastic opening tool to pry the circuit board from the housing.

  6. Locate the defective charging port. Turn the circuit board over to expose the charging solder. Using a soldering iron, remove the solder and the charging port. Install a new charging port and solder.
    • Locate the defective charging port.

    • Turn the circuit board over to expose the charging solder.

    • Using a soldering iron, remove the solder and the charging port. Install a new charging port and solder.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Josh Hendricks

Membro da: 17/09/2015

452 Reputazione

4 Guide realizzate

Team

IUPUI, Team 3-2, Harley Fall 2015 Membro di IUPUI, Team 3-2, Harley Fall 2015

IUPUI-HARLEY-F15S3G2

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 2

Ultimi 30 Giorni: 8

Tutti i Tempi: 379