Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the router over so that all four of its feet are facing upwards.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the rubber inserts inside the the two purple feet located on the router's front case.
-
This may be a challenge, so try the following two methods:
-
Use a plastic opening tool. Insert the flat end of the tool into the seam and slowly pry the rubber feet out.
-
Use a metal spudger. Insert the point of the metal spudger directly into the hole of the rubber feet and pry the insert out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a Phillips #2 Screwdriver to remove the two 5.8 mm screws holding the front case to the motherboard.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Squeeze the sides of the router's backcase inward and pull off the purple front case. It is helpful to have a second person assist you for this step.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the circuit board over and use a Phillips #2 Screwdriver to remove the 6.9mm screw holding the board to the back case.
-
Slide the back cover out and away from the circuit board.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Turn the circuit board over.
-
Identify the solder connections on the board, marked in red.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Desolder the connection by following iFixit's guide to repairing soldered connections: Come saldare e dissaldare componenti elettrici.
-
Remove the Power Connector from the board.
-
Insert the replacement power port and resolder the connectors.
-