Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Press down on the battery cover and slide outwards to open.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove a total of four 5mm JIS #000 screws from around the camera:
-
Two screws from the right side.
-
Two screws from the left side.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single 5mm Phillips #00 screw from the bottom.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Open the flash module.
-
Remove the two 6mm JIS #00 screws found inside of the flash housing.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to pry apart both halves of the camera.
-
Remove the back panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove these three JIS #000 screws from the control board:
-
5mm screw.
-
4mm screw.
-
2mm screw.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pull the small metal switch plate to the side.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Pry the LCD screen out of the metal housing plate with a plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.
-
Pull the orange cable out of the socket.
-