Salta al contenuto principale

Introduzione

Replace your Kindle's old motherboard with a new one.

  1. Using a spudger or plastic opening tool, gently pry the bezel from the screen. It is easier to start in the corners and work your way around the bezel. Do not insert the spudger too far under the bezel; it could easily damage the screen.
    • Using a spudger or plastic opening tool, gently pry the bezel from the screen. It is easier to start in the corners and work your way around the bezel.

    • Do not insert the spudger too far under the bezel; it could easily damage the screen.

  2. Remove the eleven 3.0 mm Phillips screws surrounding the midframe. At the top of the display, a strip of black tape covers one screw. At the top of the display, a strip of black tape covers one screw.
    • Remove the eleven 3.0 mm Phillips screws surrounding the midframe.

    • At the top of the display, a strip of black tape covers one screw.

  3. Lift the midframe out of the case.
    • Lift the midframe out of the case.

    • If the midframe is stuck, slide it to the left first, and then lift it out.

  4. Turn over the midframe to locate the battery. Remove the three Phillips 3.0 mm screws securing the battery to the midframe.
    • Turn over the midframe to locate the battery.

    • Remove the three Phillips 3.0 mm screws securing the battery to the midframe.

  5. Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now

    Kit di riparazione batterie iPhone

    Solo $29.99

    Buy Now
  6. Gently lift the battery from the bottom, and slide it out of the midframe.
    • Gently lift the battery from the bottom, and slide it out of the midframe.

  7. With the case and battery removed from the midframe, begin removing all cables attached to the motherboard. Place the device so the midframe's backside faces up. Start with the cable on the bottom left corner. Use a spudger to lift up the white locking cable tensioner and slide the flex cable out.
    • With the case and battery removed from the midframe, begin removing all cables attached to the motherboard.

    • Place the device so the midframe's backside faces up. Start with the cable on the bottom left corner.

    • Use a spudger to lift up the white locking cable tensioner and slide the flex cable out.

    • Proceed counterclockwise to the next cable and repeat. Small flex cable on the bottom won't need cable tensioner lifted, just carefully pull out.

  8. Remove the white flex cable by gently lifting the yellow plastic connector. Remove the white flex cable by gently lifting the yellow plastic connector.
    • Remove the white flex cable by gently lifting the yellow plastic connector.

  9. Remove the yellow anti-static tape from the display ribbon cable connector. Use a spudger to lift up and disconnect the cable tensioner. Use a spudger to lift up and disconnect the cable tensioner.
    • Remove the yellow anti-static tape from the display ribbon cable connector.

    • Use a spudger to lift up and disconnect the cable tensioner.

  10. Use a Philips screwdriver to remove the seven 3.0 mm Phillips screws securing the motherboard: Three silver screws with silver washers
    • Use a Philips screwdriver to remove the seven 3.0 mm Phillips screws securing the motherboard:

    • Three silver screws with silver washers

    • Two silver screws with no washers

    • One black screw with a golden washer

    • One black screw with a square washer

  11. Remove the motherboard.
    • Remove the motherboard.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Altre 3 persone hanno completato questa guida.

Isabelle Burgess

Membro da: 23/01/2013

1.112 Reputazione

2 Guide realizzate

Team

Cal Poly, Team 3-33, Amido Winter 2013 Membro di Cal Poly, Team 3-33, Amido Winter 2013

CPSU-AMIDO-W13S3G33

4 Membri

10 Guide realizzate

Not sure if this is an error, but on the 3G paperwhite, we needed to use a #0 Phillips, not a #2. Great guide otherwise!

Caleb Begly - Replica

Please suggest what type of controller is used and the model and flash memory in the Kindle Paperwhite 1st Generation?

ven 1949, div 0004

Elecrash - Replica

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 18

Ultimi 30 Giorni: 89

Tutti i Tempi: 15,944