Salta al contenuto principale

Introduzione

You will need to use a soldering device to replace the antenna. Let the soldering device heat up before starting the project.

  1. Flip your device over so the back panel is facing up.
    • Flip your device over so the back panel is facing up.

  2. Unscrew the 4mm screws shown. Unscrew the 4mm screws shown.
    • Unscrew the 4mm screws shown.

  3. Separate the two pieces of the device. Remove the circuit board and speaker from the plastic casing.
    • Separate the two pieces of the device.

    • Remove the circuit board and speaker from the plastic casing.

  4. Use the soldering device to melt the antenna at the point shown.
    • Use the soldering device to melt the antenna at the point shown.

    • Remove the antenna from the circuit board.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Amin

Membro da: 13/02/2016

621 Reputazione

5 Guide realizzate

Team

IUPUI, Team 1-1, Wilson Spring 2016 Membro di IUPUI, Team 1-1, Wilson Spring 2016

IUPUI-WILSON-S16S1G1

4 Membri

5 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 1

Ultimi 7 Giorni: 3

Ultimi 30 Giorni: 10

Tutti i Tempi: 563