Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using a metal spudger, peel back the foam pad on the bottom of the device to reveal six screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the six 20 mm T6 screws from the bottom of the device.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the back plate and the grey foam underneath.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a small, pointed metal spudger to release the plastic tabs connecting the faceplate to the bottom of the speaker.
-
Slowly flip the device open like a clam shell.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using the T6 Torx Screwdriver, remove the four (4mm) screws.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
After removing the screws, take out the center covering to free the motherboard by lifting the tabs and pulling it off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Peel off the white adhesive to desolder the connections underneath.
-
Desolder the wires connected to the motherboard.
-
Annulla: non ho completato questa guida.
Altre 4 persone hanno completato questa guida.
3 Commenti
Great walk-through... thanks
Be very careful when desoldering the connector cables! The soldering lugs are poor quality and tend to tear off the PCB