Introduzione

The wheelie bar may be deformed or just get in your way constantly. Learn how to remove and/or replace it with this guide.

If you need more assistance, visit our troubleshooting guide here.

Parti

Nessuna parte richiesta.

Facing the wheelie bar as shown, place your left thumb on the bolt located on the left side of the back wheel and place the Allen wrench into the screw on the right side of the back wheel.
  • Facing the wheelie bar as shown, place your left thumb on the bolt located on the left side of the back wheel and place the Allen wrench into the screw on the right side of the back wheel.

  • Using the wrench, slowly unscrew the bolt while applying constant pressure from the left side.

Aggiungi Commento

Remove the bolt from the right side and the bearing from the left.
  • Remove the bolt from the right side and the bearing from the left.

Aggiungi Commento

  • Turn the JD Razor 2000 on its side as shown. Slowly remove the back wheel by pulling it out at a perpendicular angle to the scooter base.

Aggiungi Commento

  • Pull the wheelie bar away from the deck of the scooter.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

If you need more assistance, visit our troubleshooting guide here.

Shane

Membro da: 18/10/2014

358 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 4-46, Amido Fall 2014 Membro di Cal Poly, Team 4-46, Amido Fall 2014

CPSU-AMIDO-F14S4G46

4 Membri

8 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 1

Ultimi 30 Giorni: 13

Tutti i Tempi: 644