Introduzione

The Insignia 2-in-1 stick vacuum power button can suddenly stop working or become jammed. In either case, use this guide to fix or replace the power button.

Parti

Nessuna parte richiesta.

Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle.
  • Remove the four 12mm Phillips screws , and the one large 32mm Phillips head bolt from the vacuum handle.

  • Pull up on the back cover of the vacuum handle and remove it.

Aggiungi Commento

Remove the two 10mm Phillips #2  screws on the back of the green printed circuit board.
  • Remove the two 10mm Phillips #2 screws on the back of the green printed circuit board.

  • If the circuit board needs to be replaced, locate where the two white wires are soldered to the board, and de-solder the connection.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Membro da: 15/02/2018

428 Reputazione

5 Guide realizzate

Team

USF Tampa, Team S16-G3, Boczar Spring 2018 Membro di USF Tampa, Team S16-G3, Boczar Spring 2018

USFT-BOCZAR-S18S16G3

4 Membri

6 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 0

Tutti i Tempi: 42