Salta al contenuto principale

Aggiusta la tua roba

Diritto alla Riparazione

Store

Introduzione

Follow this guide to replace a broken throttle lever on the Honda FC600 tiller.

  1. Before you begin, it's important that you completely cut power to the tiller by disconnecting the spark plug. This will prevent the engine from accidentally starting up while you're working on the tiller. Grab the spark plug cap and pull it straight out to disconnect the spark plug from the engine. Grab the spark plug cap and pull it straight out to disconnect the spark plug from the engine.
    • Before you begin, it's important that you completely cut power to the tiller by disconnecting the spark plug. This will prevent the engine from accidentally starting up while you're working on the tiller.

    • Grab the spark plug cap and pull it straight out to disconnect the spark plug from the engine.

  2. Push the throttle lever all the way down. Push the throttle lever all the way down.
    • Push the throttle lever all the way down.

  3. Remove the 23 mm-long Phillips #2 screw securing the throttle lever to the handlebar.
    • Remove the 23 mm-long Phillips #2 screw securing the throttle lever to the handlebar.

    • This screw is accompanied by a square nut. Make sure to retain it for re-assembly.

  4. Use a pair of needle-nose pliers to remove the small clip attached to the throttle cable. Use a pair of needle-nose pliers to remove the small clip attached to the throttle cable.
    • Use a pair of needle-nose pliers to remove the small clip attached to the throttle cable.

  5. Grab the open end of the throttle cable and pull it out of the throttle lever to free it from its recess. Grab the open end of the throttle cable and pull it out of the throttle lever to free it from its recess.
    • Grab the open end of the throttle cable and pull it out of the throttle lever to free it from its recess.

  6. Continue to lift the throttle cable out of the throttle lever, making sure it clears the openings in the recess. Continue to lift the throttle cable out of the throttle lever, making sure it clears the openings in the recess. Continue to lift the throttle cable out of the throttle lever, making sure it clears the openings in the recess.
    • Continue to lift the throttle cable out of the throttle lever, making sure it clears the openings in the recess.

Conclusione

To reassemble your device, follow these instructions in reverse order.

Craig Lloyd

Membro da: 10/02/2016

16.213 Reputazione

80 Guide realizzate

Team

iFixit Membro di iFixit

Community

133 Membri

14.596 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 4

Ultimi 30 Giorni: 38

Tutti i Tempi: 249