Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop upside down so that the lid lies flat on the table.
-
Remove the nine 6mm Phillips #00 screws that line the border.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two rubber feet closest to the hinge using tweezers.
-
Remove the two 6mm Phillips #00 screws revealed under these rubber feet.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the laptop so it is in the upright position.
-
Open the lid.
-
Unsnap the keyboard mount along the border of the laptop using a plastic opening tool.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Tilt the keyboard mount up.
-
Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard.
-
Gently remove both ribbon cables.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Flip the keyboard mount upside-down.
-
Using tweezers, peel off the two pieces of copper tape that keep the keyboard’s metal cover attached to the keyboard mount.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Using tweezers, pull back the three metallic-colored pieces of tape near the top left corner of the keyboard mount.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 4 mm Phillips #00 screws located on either side of the horizontal black fastener located directly above the touchpad.
-
Lift the horizontal black fastener.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to pry the edges of the metal cover.
-
Loosen the adhesive around the perimeter of the metal cover.
-
Lift the metal cover.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Use a plastic opening tool to disconnect the keyboard from the keyboard mount by prying along the keyboard’s perimeter.
-
After removing enough adhesive, remove the keyboard’s backing.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.
Un commento
Is it possible to get a keyboard that lights up for the HP Chromebook 11 G3? If so then how?