Introduzione

Removing the logic board from the Garmin Nuvi 200

Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

Aggiungi Commento

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

Aggiungi Commento

  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

Aggiungi Commento

  • Peel away the tape holding the ribbon cable in place.

  • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

Aggiungi Commento

  • Pull out the cable between the logic board and the speaker to disconnect them.

Aggiungi Commento

  • Remove the three screws from the logic board using the #00 Phillips screwdriver.

  • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

Aggiungi Commento

  • Detach the logic board form the battery by pulling out the cable.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Un'altra persona ha completato questa guida.

Anjelica

Membro da: 11/04/2010

504 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 25-90, Amido Spring 2010 Membro di Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 Membri

9 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 12

Tutti i Tempi: 9,573