D-Link DIR-890L Power Adapter Port Replacement

Introduzione

The power adapter port is on the back of the router. This is where the power cable plugs into your router, and then plugs into the wall. If this port is damaged in any way, the cable cannot be plugged in and thus you will not be able to give power to your device.

This guide requires desoldering, which is an advanced skill.

Cosa ti serve

Passo 1 Case

D-Link DIR-890L Power Adapter Port Replacement, Case: passo 1, immagine 1 di 3

D-Link DIR-890L Power Adapter Port Replacement, Case: passo 1, immagine 2 di 3

D-Link DIR-890L Power Adapter Port Replacement, Case: passo 1, immagine 3 di 3

Peel off the four rubber rectangular feet with your fingers.
The feet may be hard to remove. Apply additional force if necessary.

Modifica

Passo 2

D-Link DIR-890L Power Adapter Port Replacement: passo 2, immagine 3 di 3

Unscrew the 5mm screws in each corner using the Phillips #1 screwdriver.

Modifica

Passo 3

D-Link DIR-890L Power Adapter Port Replacement: passo 3, immagine 3 di 3

Wedge the opening tool between the red top panel and the gray bottom panel.
Twist the opening tool to separate the panels. Work your way around the case until both of the panels are separated.

Modifica

Passo 4 Motherboard

D-Link DIR-890L Power Adapter Port Replacement, Motherboard: passo 4, immagine 1 di 1

Orient the router so the narrow end of the router faces you and the ports face away from you.
The six, hot-glued antenna connections are in the middle and at the top right of the motherboard.

Modifica

Passo 5

D-Link DIR-890L Power Adapter Port Replacement: passo 5, immagine 3 di 3

Pry off the antenna connectors using a heavy-duty spudger.

Modifica

Passo 6

Continue to pry off the last three antenna connections on the upper right portion of the motherboard.

Modifica

Passo 7

D-Link DIR-890L Power Adapter Port Replacement: passo 7, immagine 3 di 3

Open the plastic bracket enclosing the three antenna wires and pull the wires out with your hands.

Modifica

Passo 8

D-Link DIR-890L Power Adapter Port Replacement: passo 8, immagine 3 di 3

Pull the yellow tape off of the motherboard to release the final antenna wire.

Modifica

Passo 9

Pull the the motherboard away from the case to remove it. Start on the side closest to you, and pull up and out.

Modifica

Passo 10 Power Adapter Port

D-Link DIR-890L Power Adapter Port Replacement, Power Adapter Port: passo 10, immagine 1 di 3

D-Link DIR-890L Power Adapter Port Replacement, Power Adapter Port: passo 10, immagine 2 di 3

D-Link DIR-890L Power Adapter Port Replacement, Power Adapter Port: passo 10, immagine 3 di 3

Locate the power adapter port at the top left of the motherboard.
Flip the motherboard over.
Locate the 3 solder joints that connect the power adapter port to the motherboard.