Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the four 2.0 mm Phillips screws of the camera using the J00 bit from the 54-bit Driver Kit. There are two screws on both sides.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4.0 mm Phillips screw located on the bottom of the camera.
-
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the front face panel of the camera by hand using firm pressure.
-
If one point of the face is stuck to the body, check if there is a screw preventing the front face from coming off.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the rear panel of the camera by hand using firm pressure.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the user interface panel by hand. The panel may fall out on its own, this is normal.
-
Replace the user interface panel by setting it in position.
-
Annulla: non ho completato questa guida.
Altre 2 persone hanno completato questa guida.