Introduzione

The bottom panel can be easily removed, and allows access for replacement on other parts of the camera.

Parti

Nessuna parte richiesta.

Open up the battery door.
  • Open up the battery door.

Aggiungi Commento

Remove the batteries from the camera by sliding them out into your palm.
  • Remove the batteries from the camera by sliding them out into your palm.

Aggiungi Commento

  • Release the side latch to open the back panel.

Aggiungi Commento

  • Remove the two black 4.5mm screws above and below the latch.

Aggiungi Commento

  • Using your finger, carefully pry open the side panel from the top of camera.

  • Pull panel downwards to remove.

  • Make sure to keep track of the small black piece of rubber under the latch.

Aggiungi Commento

  • Remove the two silver 6mm Phillips #1 screws.

Aggiungi Commento

  • Flip camera over to the bottom.

  • Remove the one 5mm Phillips #1 silver screw.

Aggiungi Commento

  • Remove the front panel by pulling away from the side with the lever.

Aggiungi Commento

  • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

  • Remove five black 4.8mm Phillips #1 screws.

Aggiungi Commento

  • Simply remove the bottom panel by prying it off with your finger.

  • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

  • Be wary of a loose piece of foam attached to the bottom panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Tammy Kong

Membro da: 23/01/2014

643 Reputazione

6 Guide realizzate

Team

Cal Poly, Team 6-20, Maness Winter 2014 Membro di Cal Poly, Team 6-20, Maness Winter 2014

CPSU-MANESS-W14S6G20

4 Membri

11 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 0

Ultimi 7 Giorni: 0

Ultimi 30 Giorni: 3

Tutti i Tempi: 265