Questa versione può contenere modifiche errate. Passa all'ultima istantanea verificata.
Cosa ti serve
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the two 4.8 mm black screws above the lens on the front of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the 4.8 mm black screw on the left side of the camera.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the front panel by lifting it away from the camera's body.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove seven 4.25 mm black screws on the bottom panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove two 6.5 mm black screws from the panel.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the plastic remote control socket cap by pulling it straight out.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Slide the panel toward the bottom of the camera to remove.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Remove the single 4.8 silver screw from the control socket.
-
-
Questo passaggio è privo di traduzione. Aiuta a tradurlo
-
Desolder connections to replace the remote control socket.
-
3 Commenti
i have this camera and the door that holds the film in will not stay closed because the plastic piece has broken at the release point. Which piece is it that I need to replace?
That's a bit of a bugger. The piece that's broken off is most likely the little "hook" on the "door" (the proper name of this "door" would be "back").
Since this little hook is integral with the back, you'd have to replace the entire back.
If you still have the piece that has broken off, it may be possible to glue it back in place, but you'd have to reinforce it with e.g. a small piece of aluminium sheet cut from a soft drink can or something like that. Use cyanoacrylate glue (otherwise known as "superglue") and make sure the pieces are clean and fit perfectly before applying the glue. You need only a tiny drop.
The EOS 30 is a film camera and therefore does not have an A/V Port, since it does neither Audio nor Video. The socket near the bottom on the grip side is for a wired remote control.