Introduzione

Removing the grip is necessary to reach the battery door. This process is safe and easy.

Parti

Nessuna parte richiesta.

Remove the two 4.8 mm black screws above the lens on the front of the camera.
  • Remove the two 4.8 mm black screws above the lens on the front of the camera.

Aggiungi Commento

Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.
  • Remove the 4.3 mm black screw under the lens ring, and the 4.8 mm black screw under the camera.

Aggiungi Commento

  • Remove the 4.8 mm black screw on the left side of the camera.

Aggiungi Commento

  • Remove the front panel by lifting it away from the camera's body.

Aggiungi Commento

  • Slide the outer eyepiece upward to remove it.

Aggiungi Commento

  • Remove the two 4.75 mm black screws located on the top of the camera.

Aggiungi Commento

  • Remove the four 4.3 mm black screws near the bottom corners of the eyepiece at the back of the camera.

Aggiungi Commento

  • Slowly separate the top panel from the camera by pushing it upward.

  • Separating the top panel too far or quickly can damage the ribbon cable and connecting wires that are still attached to the top panel of the camera.

Aggiungi Commento

  • Remove two 6.5 mm black screws from the panel.

Aggiungi Commento

  • Remove the plastic remote control socket cap by pulling it straight out.

Aggiungi Commento

  • Slide panel toward bottom of camera to remove.

Aggiungi Commento

  • Remove the two 5.5 mm screws from front of camera.

Aggiungi Commento

  • Remove grip panel.

Aggiungi Commento

Conclusione

To reassemble your device, follow these instructions in reverse order.

Jackie

Membro da: 17/04/2011

218 Reputazione

3 Guide realizzate

Team

Cal Poly, Team 8-8, Regan Spring 2011 Membro di Cal Poly, Team 8-8, Regan Spring 2011

CPSU-REGAN-S11S8G8

5 Membri

11 Guide realizzate

Aggiungi Commento

Visualizza Statistiche:

Ultime 24 Ore: 5

Ultimi 7 Giorni: 9

Ultimi 30 Giorni: 22

Tutti i Tempi: 2,843